Single-Phase Modeling Gel, transparent pink PNB UV/LED One Phase Builder Gel Crystal Pink
- 商品の詳細情報
- 詳細
-
Age:
18+
Volume: 15 ml, 50 ml
Classification: professional
Country: USA
Made in: USA
A beautiful, neat, and well-maintained manicure is an essential part of one's appearance. It is unbecoming for a lady to shyly hide her hands in her pockets if her nail polish is chipped or if her nails look untidy in general. Thanks to current nail enhancement technologies, it's possible to acquire fierce claws in just a few seconds.
A qualified nail service professional can assist you in this, using the UV/LED One Phase Builder Gel Crystal Pink from the professional American brand PNB. It has a light, maximally natural nude shade and possesses good adhesive properties. It is necessary to apply and evenly distribute a thin layer of the product onto a tip or form, allowing it time to polymerize for 2 minutes under a UV lamp and 60 seconds under an LED lamp. The medium viscosity and self-leveling ability make the PNB UV/LED One Phase Builder Gel Crystal Pink a real find not only for practicing professionals but also for beginners.
How to use: 1. Degrease the nail surface with Nail Prep. Push back the cuticle, remove shine from the nail plate with a 180/240 grit buffer. Remove dust. Apply Nail Dehydrator.
2. Apply an acid primer Acid Primer or a non-acid primer Bond Control depending on the condition of the nail plate. Use the acid primer when the nail plate is very moist; for normal conditions, the non-acid primer is suitable. Acid Primer should be applied with a semi-dry brush in a small amount, avoiding contact with the skin. The product evaporates by itself from the plate.
3. Use the gel UV/LED Builder Gel Crystal Clear/Crystal Pink as a base, chosen according to preference. Apply it in a thin layer with rubbing movements. Cure under an LED lamp for 30-60 sec. 4. Sequentially set a form on each finger and lay out a thin substrate of the desired length and shape, modeling the architecture of the nails with the gel of the chosen shade. To create an arch, you can pinch the gel at 7-12 seconds, depending on the lamp. Then, send it to the lamp for full polymerization of the gel for 60 seconds.*
5. Remove the residual stickiness with Gel Cleanser.
7. Perform a step-by-step file with a 180/240 grit file.
8. Apply the finishing coat UVLED Quick Top to add shine and protect against chips and scratches, curing for 60 sec.
*If the nail plate is thin and moist - the use of Bio Base as a base coat might be possible. It should be applied in a very thin layer with rubbing movements on a previously prepared nail, curing in the lamp for 30 seconds.